em/em.0x45.cz
1
0
Fork 0
Code Actions
master
em.0x45.cz/content/posts/hacking-a-smart-philips-lightbulb/index.md
Emil Miler aec76798e0 Add local content
2024-10-07 20:55:08 +02:00

3.9 KiB
Raw Permalink Blame History

+++ title = "Hacking a smart Philips lightbulb" date = 2021-12-29

[taxonomies] categories = ["Hardware", "IoT"]

[extra] author = "Emil Miler" +++

I got my hands on a Xiaomi Philips smart LED lightbulb (ESP8266) and my goal was to hack it, install custom firmware and effectively get rid of the Xiaomi botnet.

Hardware & disassembly

The bulb has a fixed colour temperature of 2700K, uses 9W and outputs up to 806lm. It is built on ESP8266, precisely esp-wroom-02d. This means that installing custom ESP-compatible firmware is possible -- for instance Tasmota. The rest is just a simple power supply and LED array.

There are several versions of this lighbulb and I could not find anything about this particular version. The main differences seem to be the entire PCB and housing. Most of the older versions are accessible without much force.

I started by popping off the light diffuser. This takes just a bit of prying, since it is lightly glued to the base. After taking out two screws, the LED array can be unplugged and taken out of the assembly. This leaves the ESP antenna exposed, but the rest of the board is still inaccessible.

There is no way of getting into this particular model without a bit of cutting. I took my dremmel and cut out part of the almuninum casing/heatsink to get to the PCB. This made the important part of the board accessible and exposed all the relevant pins.

Accessing UART

In order to be able to communicate with the device, we need to connect RX and TX pins, 3.3V and GND. We also need access to the IO0 pin used for enabling the UART download mode.

I soldered wires to the relevant pins and connected them to my USB-TTL programmer. Don't forget that RX and TX should be crossed, so RX on the ESP should lead to TX on the programmer.

To access the UART download mode, the chip has to have IO0 pulled to ground during boot. This can be done simply by shorting the pin to ground.

Building and flashing Tasmota

I used PlatformIO for the firmware compilation and flashing. You have to be a member of the dialout group in order to be able to access the device.

git clone https://github.com/arendst/tasmota/
cd tasmota
platformio run -e tasmota --target upload --upload-port /dev/ttyUSB0

After configuring basic network access, the firmware has to be set to generic and GPIO15 to PWM1. Here is a configuration template:

{"NAME":"Xiaomi Philips","GPIO":[0,0,0,0,0,0,0,0,0,0,0,37,0],"FLAG":0,"BASE":18}

Troubleshooting

I got suck for a long while at a problem where the ESP refused to respond or was sending invalid data. My first thought was to make both data wires shorter and set lower baudrate to eliminate noise, which did not help. I then tried to supply external power, as recommended in the official troubleshooting documentation, without much luck.

It turned out to be caused by the programmer itself. The first programmer I used had a Prolific PL-2303HX chip. The communication started working after using a different programmer with an FTDI chip and modifying it to output 3.3V instead of 5V. That can be done by simply cutting the default short between 5V and the middle pin and creating a solder jumper from 3V instead.

References